DIY Deer Head

This may have to be my next DIY project! Honestly, I can't decide If I love it or just think it's silly, but either way it makes me smile. I came across the idea reading the inspiring MadeByGirl blog, excerpted from the upcoming book "Dorm Decor", you can find their blog and the templates for the deer head here.

Here's what you'll need to make this little guy above:

Deer templates
1 20″ x 30″ piece (3/16″-thick) foam core
1 6″ x 7″ piece (1/2″-thick) foam core
60″ length (30″-wide) wrapping paper
1 6″ x 7″ piece of contrasting paper
Craft knife
Cutting board
Spray adhesive
Picture-frame hanging wire
Awl

Make the pieces

1. Using the deer templates:
From the 3/16″ thick foam core, cut:
2 deer heads
1 deer body
1 deer nose
1 deer antler
From the 1/2″ thick foam core, cut:
1 mounting board

Cover the pieces

2. Using spray adhesive, spray one side of the nose piece and adhere it to the Wrong side of the wrapping paper. Use the craft knife and the cutting board and cut out the nose piece. Repeat for the other side of the nose.

3. Repeat to cover both sides of the two deer heads, the deer body, and the deer antler pieces.

4. Using spray adhesive, adhere the contrasting paper to one side of the mounting board. Cut it out using the craft knife and cutting board.

Hang the deer head

5. On each deer head piece, cut a hole 1″ below the top edge and 3/8″ inside the back edge with the awl.

6. Assemble the deer head as shown in the photograph.

7. Thread wire through both holes several times and end by wrapping the wire around itself for a hanger